Mile Marker PE Series Installation And Operator's Manual page 19

SEC/SI Series Winch Systems
Winch Operation Cont'd
Instructions
1. Disengage the clutch by moving the Clutch Lever
to Disengage Position (or Freespool mode)(Fig. 4-1).
2. Reel-out the cable and connect to the desired an-
chor point (self recovery) or vehicle being recovered.
3. Fully Engage the clutch by moving the Clutch Le-
ver to Engage Position(Fig. 4-1).
4. Lift the protective boot covering the hand control
plug-in. Insert the hand control plug. The remote
control BLUE lights should TURN ON. (Fig. 4-2)
5. Start winching IN (GREEN lights on the remote
control should TURN ON, Figs.4-3 & 4-4) slowly to
remove the slack on the cable and ensuring that the
4-3: Hand Control Function
cable is winding onto the drum properly (with out
any overlapping or gaps). Never disengage the clutch
while the cable is under load!
6. When finished winching, slowly let off the load
by winching OUT (RED lights on the remote control
should TURN ON), unhook the cable and re-wind the
cable onto the drum (Fig. 4-3).
7. Unplug the hand control and push the protective
boot cover back on to the Plug-in (Fig. 4-5).
4-4: Hand Control Operation
4-1: Clutch Engagement
4-5: Hand Control Removal: Push Button to Release
19
4-2: Hand Control Connection to Box