Mile Marker PE Series Installation And Operator's Manual page 16

PE/E Series Winch Systems
Winch Operation Cont'd
Instructions
1. Disengage the clutch by moving the Cam Ring to
OUT Position (or Freespool mode) (Fig. 3-1).
2. Reel-out the cable and connect to the desired an-
chor point (while self recovery) or vehicle being re-
covered.
3. Fully Engage the clutch by moving the Cam Ring
to IN Position (Fig. 3-1).
4. Lift the protective boot covering the hand control
plug-in. Insert the hand control plug. The remote
control's BLUE lights should TURN ON. (Fig. 3-2)
5. Start winching IN (GREEN lights on the remote
control should TURN ON, Figs. 3-3 & 3-4)) slowly
to remove the slack on the cable and ensuring that
3-3: Hand Control Function
the cable is winding onto the drum properly (with
out any overlapping or gaps). Never disengage the
clutch while the cable is under load!
6. When finished winching, slowly let off the load
by winching OUT (RED lights on the remote control
should TURN ON, Fig. 3-3), unhook the cable and re-
wind the cable onto the drum.
7. Unplug the hand control and push the protective
boot cover back on to the Plug-in (Fig. 3-5).
3-4: Hand Control Operation
3-1: Clutch Engagement
3-5: Hand Control Removal: Push Button to Release
16
3-2: Hand Control Connection to Box