Cutting The Media; V-Shaped Cutting; Chapter 3 Cutting - MIMAKI JV330 Series Operation Manual

2.13 Cutting the media

1
On the LOCAL mode screen, press
• The Origin Setup screen appears.
2
Press to feed the media to the position required for cutting.
3
Select [CUT].
4
Select a cutting method.
• [Horizontal Cut]: The media edge is cut straight.
• [Horizontal + V Cut]: The media is cut straight and then cut into a V shape.
Cutting"(P. 91)
5
Press the [ENTER] key.
• The media is cut.
• Pressing the [FUNC2] key while the [Horizontal + V Cut] run screen is displayed creates a tape
while simultaneously cutting the media. This can be used to tape the media to the paper core
(only for self-adhesive media).

V-shaped Cutting

The media edge is cut into a V shape. As only one point of the media is fixed to the paper core with adhesive
tape, the media can be wrapped around the paper core with uniform tension.
Media"(P. 67)
l Conditions where V-shaped cutting is not available
• The media width detection method is set to "MANUAL".
([MENU] > [Media Setting] > [Media Information] > [Media Width] > [Detection Type]
Do not use V-shaped cutting in the following cases!
• The remaining roll media amount is low. Otherwise there is a risk of media jamming or the print
head nozzle face coming into contact with the media, making prints dirty.
• When using low stiffness media such as tarpaulin. A media jam may occur.
• The clamp at the right media edge is raised. Some portions of the media may be left uncut.
.
91
Chapter 2 Printing
"V-shaped
"Loading the Roll
P. 161)
2