Mode Switching Of Search Dial - Sony Betacam SX DNW-A100 Maintenance Manual

1-11. Mode Switching of Search Dial

There are two kinds of operation to switch the search dial
of this unit to jog mode or shuttle mode.
. SHUTTLE/JOG button selecting
When you press the SHUTTLE button, the digital video
hybrid recorder is switched to shuttle mode.
When you press the JOG button, the digital video hybrid
recorder is switched to jog mode.
. Search dial pressing
When you press the dial, the digital video hybrid record-
er toggles between shuttle and jog modes.
It is possible to prohibit a manner of toggling.
Prohibiting Search Dial Pressing
1. Wait for 30 seconds after turning off the power.
2. Fix a lower control panel at 90d. (Refer to the
following figure.)
3. Loosen a screw on the backside of the search dial as
shown in the figure.
4. Slide the mode selection plate in the direction
indicated by the arrow until it touches the portion A.
Lower control panel
Back View
Portion A
B3 x 14
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
http://getMANUAL.com
Search dial
Mode selection plate
5. After checking that the shaft of the search dial is not
seen in the round hole of the mode selection plate and
then tighten the screw.
Back View
B3 x 14
The shaft is not seen in the round hole.
Allowing Search Dial Pressing
1. Wait for 30 seconds after turning off the power.
2. Fix a lower control panel at 90d.
3. Loosen a screw on the backside of the search dial as
shown in the figure.
4. Slide the mode selection plate in the direction
indicated by the arrow until it touches the portion B.
5. After checking that the shaft of the search dial is seen
in the round hole of the mode selection plate and then
tighten the screw.
Back View
B3 x 14
Portion B
Search dial shaft
The shaft is seen in the round hole.
1-11. Mode Switching of Search Dial
Mode selection plate
Round hole
Mode selection plate
Round hole
1-23