System Phase Alignment; Setup Menu Setting - Sony Betacam SX DNW-A100 Maintenance Manual

1-15-3. System Phase Alignment

An external reference video signal and analog composite signal (when BKDW-505/506 is used) must be
input to this unit after they are adjusted so that SC-H conforms to the specification.
When Connecting to a Digital Switcher
Fundamentally, the system phase adjustment is not necessary.
Refer to the manual of digital switcher for details.
When Connecting to a Analog Switcher
Perform the system phase adjustment referring to the manual of the analog switcher.
The system phase of this unit is adjusted by using the SYNC control and SC control of SYSTEM PHASE
on the sub control panel.
m
. Be sure to adjust in PB mode.
The system phase does not change even if the SYNC/SC control is turned in the REC mode, but it
changes when the REC mode is shifted to the PB mode.
. The playback sound may be momentarily interrupted when the SYNC/SC control is turned during tape
playback.

1-15-4. Setup Menu Setting

Video/Sync Delay Setting "ITEM-701"
Commonly, when integrating the menu into the editing system, set on "VIDEO".
To prevent the picture shift during EE/PB switching in the VTR-to-VTR edit operation, this setup menu is
set to "VIDEO".
Analog Component Input/Output Format Setting "ITEM-709" (525/60 system only)
The input (SUB-ITEM-0) and output (SUB-ITEM-1) sides are set to "D-1" or "B-CAM" according to the
operating system, respectively.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
1-15. Settings and Adjustment when Peripheral Equipment is Connected
1-29