Check After Installing - Sony Betacam SX DNW-A100 Maintenance Manual

1-17-2. Check after Installing

Equipment
BNC cable
Pre-recorded tape or Alignment tape
*
: SR5-1 (For 525/60 system)
SR5-1P (For 625/50 system)
Check
(1) Connect the BNC cable between the SDTI INPUT on
the connector panel and the SDTI OUTPUT (1 or 2) .
(2) Set the OUT REF switch on the sub control panel to
REF.
(3) Turn on the power.
n
Check that the EXT switch on the lower control panel
illuminates.
(4) Insert the pre-recorded tape or alignment tape, and
play back.
(5) Select the SDTI by the VIDEO INPUT SELECT
switch on the upper control panel.
(6) Check that the SDTI indicator illuminates.
n
If the SDTI indicator does not illuminate or blinks,
check that the harnesses or cables are connected
accurately.
(7) Eject the tape.
(8) Reset the OUT REF switch on the sub control panel to
its previous state.
(9) Disconnect the BNC cable.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
*
1-39