Sony Betacam SX DNW-A100 Maintenance Manual page 371

(11) Confirmation (Adjustment)
Confirm each specified part's level of VIDEO OUTPUT COMPONENT outputs.
If the specification is not satisfied, perform the adjustment.
Observation component
Y
R-Y
B-Y
COMPONENT Y
A
(12) To exit A20 : VPR VR, press the MENU button once.
Perform following steps (13) through (15) when the adjustment in step (11) is performed.
(13) Data save
Enter A2F : NV-RAM CONTROL, then execute "SAVE ALL ADJUST DATA".
(14) Check that the message "Save Complete" is displayed on the video monitor.
(15) To exit A2F : NV-RAM CONTROL, press the MENU button once.
(16) To exit the maintenance mode, press the MENU button three times.
(17) For DNW-A100P/A50P/A45P only
Set SUB-ITEM 1 : OUTPUT CAV LEVEL of the setup extended menu ITEM-709 : CAV LEVEL
FORMAT to "B-CAM".
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
Adjustment point (A20 : VPR VR)
Y OUTPUT LEVEL
R-Y OUTPUT LEVEL
B-Y OUTPUT LEVEL
COMPONENT R-Y
B
6-9. VPR-17 Board Replacement
Specification
A = 700 ± 7 mV
B = 700 ± 7 mV p-p
C = 700 ± 7 mV p-p
COMPONENT B-Y
C
6-133