Control Panels Removal/Installation - Sony Betacam SX DNW-A100 Maintenance Manual

Upper Lid
(1) Loosen the three fixing screws.
(2) Remove the upper lid by moving in the direction
indicated by the arrow.
For installation, perform in the reverse procedures of removal.
Side Panels
(The right and left side panels are the same in procedure.)
(1) Remove the four screws (B3
handle.
(2) Remove the four screws (B4
panel.
For installation, perform in the reverse procedures of removal.
Bottom Plate
m
. With the handle attached, place the unit on its right side
panel down for removal and installation. Lend your hand
so that the lower handle does not hang down.
. Be careful not to shock the hard disk drive when laying
the unit.
(1) Remove the six screws (B4
bottom plate.
For installation, perform in the reverse procedures of removal.

2-3-2. Control Panels Removal/Installation

n
Turn off the power and unplug the power cord before
starting the removal/installation.
Upper Control Panel
(1) Remove the upper lid.
(Refer to "2-3-1. Upper Lid, Side Panels, and Bottom
Plate Removal/Installation".)
(2) Remove the each one screw on the left and right side.
(3) Slightly pull the lower control panel forward, then pull
it more strongly to tilt the lower control panel upward
(to 90d position).
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
http://getMANUAL.com
6), and remove the
x
x 6), and remove the side
x 6), and remove the
(4) Unhook the two hooks at lower portion on the upper
control panel.
BVTT3 x 6
Lower control panel
(5) Unhook the claws at the upper control panel from the
chassis, and remove in the direction of the arrow.
Upper control panel
Claws
For installation, perform in the reverse procedures of
removal.
n
Insert the hooks at the back of the panel into the convex
portions of the chassis, then install the panel in the chassis.
(Refer to the figure below.)
BVTT3 x 6
Hook
Upper control panel
Hook
2-3. Removal/Installation of Cabinet
Hooks
BVTT3 x 6
BVTT3 x 6
2-3