Sony Betacam SX DNW-A100 Maintenance Manual page 297

METAL C adjustment [to step (9)]
(7) Observe the R-Y output signal at the component waveform monitor.
(8) Playback the multiburst signal portion (8:00 to 11:00) of the alignment tape CR5-1B or CR5-1B PS,
and adjust the level at specified frequency part by table below.
And check that levels at others are within specifications.
(DNW-A100/A50/A45: CR5-1B, DNW-A100P/A50P/A45P: CR5-1B PS)
n
As the R-Y output is overlapped the outputs of A and B channels on the component waveform
monitor, adjust/check in each channel.
Adjustment points: A channel:
B channel:
Specifications (A and B channels): See the table below.
Frequency Specification for DNW-A100/A50/A45
7T BAR Reference: 100% {0 dB}
1 MHz Adjust : 94 (100 to 89)%
0.2 MHz Check : 100 (106 to 71)% {0
0.5 MHz Check : 100 (106 to 71)% {0
1.5 MHz Check : 80 (106 to 71)%
7T BAR 0.2
100%
DNW-A100/A50/A45
(9) Observe the B-Y output signal at the component waveform monitor, confirm that the B-Y output
signal levels at every frequencies are within specifications shown above.
If the B-Y output signal is out of specifications, perform fine adjustment for R-Y until the specifica-
tions for both R-Y and B-Y output signals are satisfied.
(10) Eject the alignment tape CR5-1B/CR5-1B PS.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
A32 : DM VR 1 : EQ1 METAL-C-A
A32 : DM VR 1 : EQ1 METAL-C-B
{_0.5 ±0.5 dB}
+0.5
dB}
_3.0
+0.5
dB}
_3.0
+2.5
{_2.0 dB}
_1.0
0.5 1 1.5 2 [MHz]
Frequency Specification for DNW-A100P/A50P/A45P
8T BAR Reference: 100% {0 dB}
1.5 MHz Adjust : 93 (102 to 85)%
0.2 MHz Check : 100 (106 to 71)% {0
0.5 MHz Check : 100 (106 to 71)% {0
1 MHz Check : 100 (106 to 71)% {0
2 MHz Check : 80 (106 to 71)%
8T BAR 0.2 0.5 1 1.5 2
100%
DNW-A100P/A50P/A45P
6-4. DM-89 Board Replacement
{_0.6 ± 0.8 dB}
+0.5
dB}
_3.0
+0.5
dB}
_3.0
+0.5
dB}
_3.0
+2.5
{_2.0 dB}
_1.0
[MHz]
6-59