Sony Betacam SX DNW-A100 Maintenance Manual page 131

Supp. remarks
1. For the sub error message "Normal Playback Fail(63)", the error message of error code D8 is not
displayed in the time data display area on the lower control panel and it is not superimposed on the
video monitor. However, stores as the error logging data.
Even if this error arise, a play back is continued. As a result, any influence may appear on video and
audio (freeze, etc.).
2. When the media error occurs, HDD pauses the recording or playing back. If these errors occur
continuously, the record and playback stay a pause during which it occurs.
. During recording (SSX ROM version 3.20 and later)
As recording pause continues, the recording data accumulate in the recording buffer.
If the overflow is resolved within five seconds after the buffer becomes full, the sub error message
"Recovered Over Flow (65)" appears. Press the STOP button, and retry recording.
If the overflow is not resolved within five seconds, a sub error message "Buffer Over Flow (62)"
appears. In this case, turn the power to this unit off then on again, and retry recording.
If the sub error message "Buffer Over Flow (62)" appears, check the HDDs on which a medium
error occurs frequently with the error log, and replace the HDD.
. During recording (Earlier version than above)
When recording pause continues, the recording data accumulate in the recording buffer.
When the buffer is full, the sub error message "Buffer Over Flow (62)" appears. In this case,
turn the power to this unit off then on again, and retry recording.
. During playback
When the playback buffer is empty because no playback data are sent from the HDDs, error code
D6 is issued. In this case, playback can continue, and no error message appears.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
3-2. Details of Error Messages
3-29