Cleaning; Cleaning Using Cleaning Tape; General Information For Cleaning Using Cleaning Cloth - Sony Betacam SX DNW-A100 Maintenance Manual

Digital video hybrid recorder
Hide thumbs Also See for Betacam SX DNW-A100:
Table of Contents

Advertisement

5-2. Cleaning

To make the most of the functions, fully realize the performance of this unit, and to
lengthen the life of the unit and tape, clean the components often.

5-2-1. Cleaning using Cleaning Tape

If the video heads are clogged, clean the video head as the following procedure.
Make sure to use the specified cleaning tape. If other tape is used, unusual abrasion
or damage of the video heads may occur.
Specified cleaning tape:
BCT-5CLN
Procedure
1. Insert the cleaning tape BCT-5CLN to the unit.
2. Press the EJECT and PLAY buttons simultaneously.
The cleaning tape is played back for approx. 5 seconds. After that, the cleaning
tape will be ejected automatically.
m
. If the cleaning tape is not ejected after playing back more than 5 seconds, be
sure to press the EJECT button immediately to eject the cleaning tape.
. Do not be place the cleaning tape in the STOP mode, and do not put the unit
in fast-forward and rewind modes, because the video heads may be damaged.
3. Check to see that the head clogging is clear.
If the video heads are still clogged after cleaning using a cleaning tape, clean them
using a cleaning cloth. (Refer to Section 5-2-3.)

5-2-2. General Information for Cleaning using Cleaning Cloth

1. Cautions
. Be sure to turn the power off before cleaning.
. Each block in the mechanical deck consists of a precision part and is adjusted
precisely. Be careful not to damage each part and to apply an excessive force
during cleaning.
. Do not contact the greased portions during cleaning. If the grease smears to a
cleaning cloth, use a new cloth to aviod allow the grease to contact places where it
should not.
. Do not insert a cassette tape before a cleaning fluid completely evaporates after
cleaning.
2. Preparation
1. Turn the power off.
2. Remove the upper lid. (Refer to Section 2-3-1.)
3. Remove the plate MD assembly. (Refer to Section 2-4.)
4. Remove the cassette compartment. (Refer to Section 2-5.)
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
5-2. Cleaning
5-5

Advertisement

Table of Contents
loading

Table of Contents