Sony Betacam SX DNW-A100 Maintenance Manual page 68

1-19. Installation of BKNW-105
(6) Remove the shield plate and CP insulator (A).
n
Keep the CP insulator (A) with the CP-278 board. It
needs when installing the CP-278 board again.
Shield plate
CP insulator (A)
(7) Disconnect the harnesses from the connectors (CN191,
192 and 193) on the CP-278 board, and remove the
CP-278 board.
(8) Remove the four switch plates.
n
Keep the switch plates with the CP-278 board that is
removed in step (7).
CP-278 board
CN192
Switch plates
1-56
CN191
CN193
(9) Attach the ornamental plate by supplied screws A and
B (BVTT 3 x 6) .
(Screw in order of A,B shown in the figure.)
(10)Install the CP-308 board by supplied five screws
(BVTT 3 x 6) (shown as C in the figure) from the
connector panel side while holding the CP-308 board.
CP-308 board
Screw A
(BVTT3 x 6)
(11)Connect the three harnesses that are disconnected from
the CP-297 board in step (7) to the connectors
(CN191, 192 and 193) on the CP-308 board.
(12)Connect the two supplied harnesses between the CP-
308 board and MB-648 board.
CP-308 board MB-648 board
CN1 CN197
CN2 CN196
Harness 8-pin
(AES/EBU IN)
CN196
CN197
CN192
MB-648 board
CP-308 board
Screw B
(BVTT3 x 6)
Screws C
(BVTT3 x 6)
Ornamental plate
Screw C
(BVTT3 x 6)
Harness
6-pin (AES/EBU OUT)
8-pin (AES/EBU IN)
Harness 6-pin
(AES/EBU OUT)
CN193
CN191
CN2
CN1
DNW-A100/A50/A45
DNW-A100P/A50P/A45P