TKH security BL2002PID User Manual page 83

Our Brands: FlinQ | iProtect | Park Assist | ParkEyes | Siqura | VDG
Installations in over 80 countries
IP address refers to IPv4.
Steps
1. Go to Configuration → System → Security → IP Address Filter .
2. Check Enable IP Address Filter.
3. Select the type of IP address filter.
Forbidden IP addresses in the list cannot access the device.
Allowed Only IP addresses in the list can access the device.
4. Edit the IP address filter list.
Add Add a new IP address or IP address range to the list.
Modify Modify the selected IP address or IP address range in the list.
Delete Delete the selected IP address or IP address range in the list.
5. Click Save.
Set HTTPS
HTTPS is a network protocol that enables encrypted transmission and identity authentication, which
improves the security of remote access.
Steps
1. Go to Configuration → Network → Advanced Settings → HTTPS .
2. Check Enable to access the camera via HTTP or HTTPS protocol.
3. Check Enable HTTPS Browsing to access the camera only via HTTPS protocol.
4. Select the Server Certificate.
5. Click Save.
NOTE: If the function is abnormal, check if the selected certificate is abnormal in
Certificate Management.
Set QoS
QoS (Quality of Service) can help improve the network delay and network congestion by setting the
priority of data sending.
NOTE: QoS needs support from network device such as router and switch.
Steps
1. Go to Configuration → Network → Advanced Configuration → QoS .
2. Set Video/Audio DSCP, Alarm DSCP and Management DSCP.
NOTE: Network can identify the priority of data transmission. The bigger the DSCP
value is, the higher the priority is. You need to set the same value in router while
configuration.
TKH Security B.V. | +31 182 592 333 | info.nl@tkhsecurity.com | tkhsecurity.com
BL2002PID
User ManualBL2002PID
January 4, 2021 Meridiaan 32
2801 DA, Gouda
Page 83
The Netherlands