Network Settings; Tcp/Ip - TKH security BL2002PID User Manual

Our Brands: FlinQ | iProtect | Park Assist | ParkEyes | Siqura | VDG
Installations in over 80 countries

4.7 Network Settings

4.7.1 TCP/IP

TCP/IP settings must be properly configured before you operate the device over network. IPv4 and
IPv6 are both supported. Both versions can be configured simultaneously without conflicting to each
other.
Go to Configuration → Network → Basic Settings → TCP/IP for parameter settings.
NIC Type
Select a NIC (Network Interface Card) type according to your network condition.
IPv4
Two IPv4 modes are available.
DHCP
The device automatically gets the IPv4 parameters from the network if you check DHCP.
The device IP address is changed after enabling the function. You can use SADP to get the
device IP address.
Manual
You can set the device IPv4 parameters manually. Input IPv4 Address, IPv4 Subnet Mask,
and IPv4 Default Gateway, and click Test to see if the IP address is available.
IPv6
Three IPv6 modes are available.
Route Advertisement
The IPv6 address is generated by combining the route advertisement and the device Mac
address.
NOTE: Route advertisement mode requires the support from the router that
the device is connected to.
DHCP
The IPv6 address is assigned by the server, router, or gateway.
Manual
Input IPv6 Address, IPv6 Subnet, IPv6 Default Gateway. Consult the network administrator
for required information.
MTU
It stands for maximum transmission unit. It is the size of the largest protocol data unit that can
be communicated in a single network layer transaction. The valid value range of MTU is 1280 to
1500.
DNS
TKH Security B.V. | +31 182 592 333 | info.nl@tkhsecurity.com | tkhsecurity.com
BL2002PID
User ManualBL2002PID
January 4, 2021 Meridiaan 32
2801 DA, Gouda
Page 61
The Netherlands