TKH security BL2002PID User Manual page 39

Our Brands: FlinQ | iProtect | Park Assist | ParkEyes | Siqura | VDG
Installations in over 80 countries
It shows the condition of your memory card. There are three status descriptions: good, bad, and
damaged. You will receive a notification if the health status is anything other than good when the
Arming Schedule and Linkage Method are set.
NOTE: It is recommended that you change the memory card when the health
status is not "good".
3. Click R/W Lock to set the permission of reading and writing to the memory card.
- Add a Lock
a. Select the Lock Switch as ON.
b. Enter the password.
c. Click Save
- Unlock
● If you use the memory card on the device that locks it, unlocking will be done automatically
and no unlocking procedures are required on the part of users.
● If you use the memory card (with a lock) on a different device, you can go to HDD
Management to unlock the memory card manually. Select the memory card, and click Unlock.
Enter the correct password to unlock it.
- Remove the Lock
a. Select the Lock Switch as OFF.
b. Enter the password in Password Settings.
c. Click Save.
NOTE: ● Only admin user can set the R/W Lock.
● The memory card can only be read and written when it is unlocked.
● If the device, which adds a lock to a memory card, is restored to the factory
settings, you can go to HDD Management to unlock the memory card.
4. Set Arming Schedule and Linkage Method. See Set Arming Schedule and Linkage Method
Settings for details.
5. Click Save.
Set FTP
You can configure the FTP server to save images which are captured by events or a timed
snapshot task.
Before You Start
Get the FTP server address first.
Steps
1. Go to Configuration → Network → Advanced Settings → FTP .
TKH Security B.V. | +31 182 592 333 | info.nl@tkhsecurity.com | tkhsecurity.com
BL2002PID
User ManualBL2002PID
January 4, 2021 Meridiaan 32
2801 DA, Gouda
Page 39
The Netherlands