Table of Contents
Advertisement
Our Brands: FlinQ | iProtect | Park Assist | ParkEyes | Siqura | VDG
Installations in over 80 countries
●
If the product does not work properly, contact your dealer or the nearest
service center. Never attempt to disassemble the camera yourself. We shall
not assume any responsibility for problems caused by unauthorized repair or
maintenance.
●
An appropriate overcurrent protective device shall be incorporated external to
the equipment, not exceeding the specification of the building.
●
Ensure correct wiring of the terminals for connection to an AC mains supply.
Cautions
●
Make sure the power supply voltage is correct before using the camera.
●
Do not drop the camera or subject it to physical shock.
●
Do not touch the sensor modules with your fingers. If cleaning is necessary,
use a cleaning cloth with a bit of ethanol and wipe it gently. If the camera
will not be used for an extended period of time, put on the lens cap to
protect the sensor from dirt.
●
Do not aim the camera lens at strong light such as the sun or an
incandescent lamp. The strong light can cause fatal damage to the camera.
●
The sensor may be burned out by a laser beam, so if any laser equipment is
used, make sure that the surface of the sensor is not exposed to the laser
beam.
●
Use the unit under conditions where the temperature remains within the
range given in the Technical Specifications of this product. You can
download the datasheet of the camera at siqura.com.
●
Do not install the camera in a dusty or damp environment, and do not
expose it to high electromagnetic radiation.
●
To avoid heat accumulation, good ventilation is required to ensure a proper
operating environment.
●
Keep the camera away from water and any liquid.
●
While shipping, the camera should be packed into its original packing.
●
Improper use or replacement of the battery may result in the hazard of
explosion. Use the battery type recommended by the manufacturer.
Cautions
The following cautions apply to cameras with IR functionality. Be sure to follow them to prevent IR
reflection.
●
Dust or grease on the dome cover will cause IR reflection. Do not remove
the dome cover film until the installation is finished. If there is dust or
grease on the dome cover, clean the dome cover with a clean soft cloth and
isopropyl alcohol.
●
Make sure that the installation location does not have any reflective surfaces
of objects that are too close to the camera. The IR light from the camera
may reflect back into the lens causing a reflection in the video image.
TKH Security B.V. | +31 182 592 333 | info.nl@tkhsecurity.com | tkhsecurity.com
BL2002PID
User ManualBL2002PID
January 4, 2021
Meridiaan 32
2801 DA, Gouda
Page 10
The Netherlands
Advertisement
Table of Contents
Need help?
Do you have a question about the BL2002PID and is the answer not in the manual?
Questions and answers