TKH security BL2002PID User Manual page 79

Our Brands: FlinQ | iProtect | Park Assist | ParkEyes | Siqura | VDG
Installations in over 80 countries
Set NTP Server
You can use NTP server when accurate and reliable time source is required.
Before You Start
Set up a NTP server or obtain NTP server information.
Steps
1. Go to Configuration → System → System Settings → Time Settings .
2. Select Time Zone.
3. Click NTP.
4. Set Server Address, NTP Port and Interval.
NOTE: Server Address is NTP server IP address.
5. Click Test to test server connection.
6. Click Save.
Synchronize Time by Satellite
Steps
1. Enter Configuration → System → System Settings → Time Settings .
2. Select Satellite Time Sync..
3. Set Interval.
4. Click Save.
NOTE: The function is only supported by certain camera models.
Set DST
If the region where the device is located adopts Daylight Saving Time (DST), you can set this
function.
Steps
1. Go to Configuration → System → System Settings → DST .
2. Check Enable DST.
3. Select Start Time, End Time and DST Bias.
4. Click Save.
TKH Security B.V. | +31 182 592 333 | info.nl@tkhsecurity.com | tkhsecurity.com
BL2002PID
User ManualBL2002PID
January 4, 2021 Meridiaan 32
2801 DA, Gouda
Page 79
The Netherlands