Intended Use; Delivery Scope - LOGICDATA DCDinline D Manual

3.2 INTENDED USE

The DCDinline D actuator may only be installed in telescopic tubes to adjust electrically height-adjustable
tables and used for this purpose exclusively. The intended use is to adjust the table height electrically. Only
control units from LOGICDATA, which are parameterized for the DCDinline D, may be used for this purpose.
The actuators must be assembled, commissioned and functionally checked by qualified personnel. Any
other use that does not conform to the intended use will result in the loss of warranty and warranty claims.
The basic function is the upward and downward movement (of a table top). This function can be executed
with suitable hand switches from LOGICDATA.
NOTICE
Permissible drive loads and speeds always refer to the product DCDinline D and not to
the additional load on the table system. The reseller must take additional loads such
as e.g. friction forces, the deadweight of the table components and torque loads into
consideration. The newly determined permissible load must be specified in the parent
documentation of the final product.

4 DELIVERY SCOPE

The standard scope of delivery for the DCDinline D actuator consists of the following components:
2
Fig. 2: Delivery scope
Standard delivery scope
1 DCDinline D actuator
2 Two mounting screws incl. rubber disks (LOG-PRT-SD-MOUNTINGSCREW)
DCDINLINE D MANUAL // PAGE 9
1