Install Vga / Agp4X With Led2 & Jp11 Safeguard - SOLTEK 85MR3-R Manual

85MR3-R / 85MR3-RL
2-4 Install VGA / AGP4X with LED2 & Jp11 Safeguard
1. To install on-board VGA, please connect your monitor directly to VGA
connector on board. Default Jp11 2-3 closed is to assure booting
system with on-board VGA or 1.5V AGP4X add-on card yet without
safeguard against 3.3V AGP2X card.
* That is, if 3.3V AGP 2X card is mistakenly inserted for booting the
system, the high voltage will burn the 1.5V circuitry on board. Never
use a 3.3V or an unknow AGP card in this case.
2. To install AGP4X card on this mainboard, please insert AGP4X card
into AGP slot and connect your monitor directly to the AGP4X card.
To assure the use of a correct AGP4X card of 1.5V, please set Jp11
to 1-2 closed to allow only 1.5V AGP 4X card to boot system. With
Jp11 1-2 closed, safeguard is enabled against AGP2X card. That is,
system cannot boot with 3.3V AGP2X card or on-board VGA. In this
case, if user cannot boot with an AGP card inserted in AGP slot, it
indicates that the AGP card is a wrong one. Find a 1.5V AGP4X card
before booting this system.
3. LED2 is a Warning LED. Whenever an AGP card is not inserted to
the AGP slot, or if the card is not a correct one, LED2 will keep
lighting up until a proper installation is done.
Jp11: VGA/AGP4X Safeguard
1
1-2 closed
Safeguard against AGP2X Enabled;
1.5V AGP 4X Card to boot system only
1
2-3 closed (default)
Safeguard Disabled;
VGA or AGP 4X to boot system.
(Warning: 3.3V AGP card will cause 1.
5V circuit burn.)
1
Jp1
PS/2 Mouse
(on top)
PS/2 K/B (underside)
RJ45
(on top)
USB0 (middle)
USB1 (underside)
VGA
Connector
2 1
4 3
LED2
Jp10
RTL8100B
RTL AC'97
ALC650
Codec
1
CD1
IT8712F
LPC I/O
Audio1
14
COM3
1
1 1
LED2: AGP Warning Indicator
Fan1
1
RT2
LED1
1
Intel
Clock
Generator
i845GE
Jp11
AGP 4X
1
PCI 1
PCI 2
Intel
ICH4
PCI 3
ATA2
Jp14
JBAT1
PCI 4
1
PDC
20376
PCI 5
1
BIOS
JP15
PCI 6 ATA1
CN20 CN21
Fan3
CN19
1 1
AGP Accelerator
AGP4X Slot
Warning:
• I f a 3 . 3 V A G P 2 X c a rd i s
mistakenly inserted for booting the
system, the high voltage will burn
the 1.5V circuit on board. Never
use a 3.3V or an unknown AGP
card on this mainboard
24
4X notch