SOLTEK 85MR3-R Manual page 95

Note:
If you need to specify any additional devices to be installed, do
so at this time. Once all devices are specified, continue to step 7.
7. From the Win 2000/XP Setup screen, press the Enter key. Setup will
now load all device files and then continue the Win 2000/XP installation.
5-2.1-2 Installing Driver To Existing Win 2000/XP System
W A R N I N G :
W A R N I N G : Your must first complete installing the driver before
moving the boot drive containing the existing Win 2000/XP operating
system on to the FastTrak 376 controller (e.g. IDE3/ATA1/ATA2). On
mainboard, IDE1/2 are for system IDE controller, while IDE3 & ATA1/
2 are under RAID controller.
At booting with Win 2000/XP system and your hard drive(s) connected to
IDE1/2, Win 2000/XP setup will show a "New Hardware Found" dialog
box. Under Win 2000/XP, the "PCI RAID Controller" will be displayed.
1. In the dialog box, choose "Driver from disk provided by hardware manu-
facturer " button.
2. In the A: drive, insert the FastTrak 376 driver diskette.
3. Type "A:\WIN2000/XP" in the text box. Press "Enter".
4. Choose "Win2000/XP Promise FastTrak 376 Controller" from the
list that appears on screen, then press the "Enter" key.
5. The Win 2000/XP setup screen will appear again saying "Setup will
load support for the following mass storage device - Win2K/XP Promise
FastTrak 376 controller. The FastTrak 376 driver will now be copied
on to the system and entered into the Win 2000/XP driver database.
6. When the "System Setting Change" dialog box appears, remove
the floppy diskette and click on "Yes" to restart the system. Win
2000/XP will then restart for the driver installation to take effect.
7. Power off your system, then attach your hard drive to the FastTrak 376
controller, e.g. IDE3/ATA1/ATA2.
Chapter 5 RAID Controller
101