Overload Protection - Miller Trailblazer 325 Diesel Owner's Manual

8-6.

Overload Protection

tools/
ear plugs electrodewrench
cclamp rpmmeter
hacksaw belttensiongauge
3/8 in.
wrench
crescent wrench
fusepuller
nutdriver
sealant_2
chippinghammer
SOAP
bar soap
Liquid soap
wirecutter
OM-279836 Page 18
Thermal Compound
Trowel
OM-279836 Page 48
�
Complete Parts List is available at www.MillerWelds.com
5
helmet weldshield
benchvise
popriveter
sealant_1
3
mallet
pump pliers
Paper Clip
frontcutter
Chisel
2
1
faceshield
tape
4
259 872
scissors
Torx
Stop engine.
�
When a circuit breaker or fuse opens, it
usually indicates a more serious prob-
lem exists. Contact a Factory Author-
ized Service Agent.
1 Fuse F5
F5 protects the weld excitation winding from
overload. If F1 opens, weld output stops or is
low.
2 Supplementary Protector CB5
Protects optional Excel power windings from
overload. If this opens, Excel power is not
available at receptacle RC3.
Place switch in On position to reset.
3 Circuit Breaker CB7
CB7 protects the engine glow plug circuit. If
CB7 opens, the glow plug will not heat. CB7
automatically resets when the fault is
corrected.
4 Supplementary Protector CB8
CB8 protects the engine battery circuit. If
CB8 opens, the engine will not crank. CB8
automatically resets when the fault is
corrected.
Replace any open fuses. Close door and/or
reinstall cover before operating unit.
5 Supplementary Protector CB4
CB4 protects the stator winding supplying 24
volt AC output to Remote receptacle RC4. If
CB4 opens, 24 volt AC output to RC4 stops.
Press button to reset.