Table of Contents
Advertisement
June 2005
Module identification
The upper portion of the DSP configuration property sheet displays fields that
identify the module you are currently configuring. In the Module Number drop
down box, choose the module position on the RLC that the DSP module
occupies. Module 0 represents the built-in DSP resources on the RLC–the
equivalent of one DSP application module.
Device configuration
The middle portion of the property sheet displays information describing the
DSP loads, and corresponding compression algorithms that you can select for
each DSP device. Remote Gateway 9100 Series configures the same DSP load
to all four channels on the same device. The number of DSP devices on an RLC
determines the number of DSP loads that the RLC can accommodate.
Configuring DSPs
To configure DSP modules on your RLC, complete the following steps:
1
Access the DSP Configuration property sheet.
2
Complete the fields as described in "DSP Configuration field descriptions"
on page 226.
3
Click on the OK button.
Result: Configuration Manager writes the changes to a temporary file on
the administration PC.
4
Click on the Send button to update the RLC with the new information.
Note: To save changes to the RLC's Flash memory, select Upload
to Flash from the Menu Bar.
RLC Installation and Administration Guide
Configuring the RLC
→
Save
225
Advertisement
Table of Contents
Troubleshooting
