Caller Id Configuration - Nortel RLC Installation And Administration Manual

Configuring the RLC

Caller ID configuration

Note: This procedure applies to Remote Gateway 9150 units only.
In the list of Caller IDs dialog box, enter the DNs of every B-channel assigned to
the remote unit you are configuring. The Unit ID field of the associated Remote
Connection Configuration property sheet identifies the remote site these Caller
IDs apply to. Enter up to 20 telephone numbers using the same format used by
the PSTN for presenting these DNs, such as 10 digits or four digits. If you want
to use level 2 (Caller ID) security, you must enter the DNs of all associated B-
channels. For more information on Caller ID security, refer to "Level 2, caller ID
security" on page 21. For the proper procedure to use in Caller ID configuration,
refer to "Configuring Caller ID information" on page 223.
Getting there
RLC
List of Caller IDs
222
→
Configuration Manager
→
Caller ID
→
Remote Connection Configuration
RLC Installation and Administration Guide
Standard 4.0