Advertisement
Base Frame Block
Guide
1/4-20 X .63
Socket Head
Screws
5/16 X 2.50 Socket
Head Shoulder Screw
(Shown Exploded for
Clarity)
Fender
Mounting
Screws
Outer Rim
Cutout
Locking Tab
Mounting
Bolt
Locking Tab
Washer
Washer
Removing/Installing the Shrouds
Wheelchairs without Elevating Seat
NOTE: For this procedure, refer to FIGURE 2.
NOTE: Reverse this procedure to install the top shrouds
1. Remove or tilt the seat back. Refer to wheelchair base owner's manual.
2. Remove the two thumb screws securing the rear half of the top shroud to the
wheelchair fame.
3. Pulling up, remove the rear half of the top shroud.
4. Remove the two thumb screws securing the front half of the top shroud to the
wheelchair fame.
Part No 1154307
Motor and
Gearbox
Drive
Shaft
Wheel
NOTE: Fold locking tab washer tab down to
remove the mounting bolt. Fold one locking tab
washer tab up to install the mounting bolt.
Outer Rim
Mounting
FIGURE 1 Installing the Locking Cylinder Kit
Guide Block Clamp
Locking Cylinder
Keystock
DETAIL "A"
Bolt
7
TDX®SC/Spree Locking Cylinders
1/4-20 Locknut
Nylon Washer
Lower Bumper
5/16-18 Keps Nut and
.328 X .75 X .060 Washer
Walking Beam Assembly
Head Tube
Locking Tab
Inserted into Outer
Rim Cutout
Locking Tab
Washer Tabs
Advertisement
