Download Print this page

Invacare 1163237 Assembly, Installation And Operating Instructions page 11

Tdx sc/spree locking cylinders

Advertisement

12. Torque the two rear counter sunk socket head cap screws to 23 ft-lbs ± 20%.
13. Turn wheelchair power on and tilt the seat to the down position.
14. Turn wheelchair power off.
15. Cycle the tilt and/or recline functions to verify wiring harnesses DO NOT obstruct the
path of the system. If they do, perform one of the following:
• Wires were damaged during inspection - Replace damaged wires.
• Wires were not damaged during inspection - Cut tie-wraps and relocate wires to a
location where they will not become damaged.
16. Position the seat pan on the seat frame.
17. Using the two socket screws, secure the seat pan to the seat frame.
18. Install the seat cushion.
Rear Counter Sunk
Socket Head Cap Screw
NOTE: Components shown
exploded for clarification
purposes only. There is no
need to remove the
mounting screws and/or
clamping brackets.
Clamping
Bracket
Part No 1154307
FIGURE 1.2 TDX SC with Formula CG Tilt seat
Socket Head Cap Screw
Seat Frame/Actuator Assembly
11
TDX®SC/Spree Locking Cylinders
Front Counter Sunk
Clamping
Bracket
Interface
Mounting Plate

Advertisement

loading

This manual is also suitable for:

1163238