Advertisement
8. Disconnect multimeter connectors from the drive lockout switch connector.
9. Tighten the mounting screw to secure the drive lockout sensor in the desired position.
10. Connect the drive lockout sensor cable to the drive lockout sensor lead of the seating
system wiring harness.
11. Turn wheelchair power on and using a magnetic angle gage, tilt the seating system to
the desired seat angle less than 5°.
12. Repeat STEPS 2-10 to adjust the elevate lockout sensor.
Clamp
Elevate Lockout Sensor
Hex Head Screw and Locknut
TDX®SC/Spree Locking Cylinders
Drive Lockout Sensor
FIGURE 9 Adjusting the Sensors
24
Hex Head Screw and Locknut
Clamp
Drive Lockout
Sensor Connector
Elevate Lockout Sensor Connector
Part No 1154307
Advertisement
