Advertisement
TDX SC with ADJASBA Seat
NOTE: For this procedure, refer to FIGURE 2.
1. Remove the seat cushion.
2. Remove the two socket screws securing the seat pan to the seat frame.
3. Remove the seat pan from the seat frame.
4. Verify seat mounting location (Detail "B") and perform one of the following:
• Seat MUST be Repositioned - Proceed to STEP 5.
• Seat DOES NOT Need Repositioned - Proceed to STEP 10.
5. Remove the six socket head cap screws, ground washers, and the two strap nuts and
locknuts securing the seat frame to the adapter frame.
6. Move the seat frame to the mounting holes shown in Detail "B".
7. Apply Loctite 242
8. Using the six socket head cap screws, ground washers, and the two strap nuts and
locknuts, secure the seat frame to the adapter frame. Torque socket head cap screws to
13 ft-lbs ± 20%.
9. If necessary, re-position front riggings to ensure sufficient clearance for caster wheels.
refer to the seating system owner's manual.
10. Position the seat pan on the seat frame.
11. Secure the seat pan to the seat frame using the two socket screws.
12. Reinstall the seat cushion.
Ground
Washers
Seat
Frame
TDX®SC/Spree Locking Cylinders
®
to the six socket head cap screws.
Socket Head Cap
Screws
Ground
Washers
Adapter Frame
FIGURE 2 TDX SC with ADJASBA Seat
DETAIL "B"
NOTE: Seat frame must be mounted to the
adapter frame mounting holes shown
(according to seat rail length). If the seat
frame is not mounted in this location, then
the seat frame MUST be repositioned.
Adapter Frame
Mounting Holes
Adapter Frame
12
Part No 1154307
Advertisement
