Advertisement
24. Torque the two rear counter sunk socket head cap screws to 23 ft-lbs ± 20%.
25. Turn wheelchair power on and tilt the seat to the down position.
26. Turn wheelchair power off.
27. If necessary, re-position front riggings to ensure sufficient clearance for caster wheels.
refer to the seating system owner's manual.
28. Position the seat pan on the seat frame.
29. Secure the seat pan to the seat frame using the two socket screws.
30. Reinstall the seat cushion.
Seat Frame Assembly
(Actuator and Tilt System
Not Shown)
Seat Frame
Assembly - Rear
Rear Counter Sunk Socket
Head Cap Screws
Seat
Assembly
Actuator Post
FIGURE 4 TDX Spree with Formula CG Tilt/Elevate Seat
TDX®SC/Spree Locking Cylinders
DETAIL "D"
Seat Frame Assembly
Mounting Holes
DETAIL "E"
16
NOTE: Seat frame assembly MUST be
mounted to the actuator post and
seat-to-floor height bracket (if present)
using the mounting holes shown. If the
seat frame assembly is not mounted in
this location, then the seat frame
MUST be repositioned.
Seat Frame
Assembly - Front
Front Counter Sunk Socket
Head Cap Screws
NOTE: Seat pan, socket screws
and seat assembly not shown.
Seat-to-Floor Height Bracket
(If Present)
Locknuts or Weldnuts
Wheelchair Base Frame
Part No 1154307
Advertisement
