Advertisement
TDX Spree with ADJASBA Seat (with Manual Tilt)
NOTE: For this procedure, refer to FIGURE 6.
1. Tilt seat back.
2. Examine the location of the two large holes in the tilt elevate frame used to engage the
docking pins and the length of the tilt elevate frame (Detail "F") and perform one of
the following:
• Tilt Elevate Frame was Manufactured After 02/11/2009 - The manual tilt assembly
does not need to be replaced. Tilt the seat forward and proceed to STEP 17 of
Installing the New Locking Cylinder on page 5.
• Tilt Elevate Frame was Manufactured Before 02/12/2009 - The manual tilt assembly
must be replaced. Refer to Replacing the Manual Tilt Assembly on page 19.
NOTE: Seat frame
not shown.
FIGURE 6 TDX Spree with ADJASBA Seat (with Manual Tilt)
TDX®SC/Spree Locking Cylinders
Frame Length -
10-1/2 inches
Tilt Elevate Frame
Frame Length -
DETAIL "F"
Tilt Elevate Frame Manufactured
After 02/11/2009
Tilt Elevate
Tilt Elevate Frame Manufactured
Before 02/12/2009
Tilt Elevate
9-1/2 inches
18
Large Holes
NOTE: front
large hole located
under the front
bracket.
Large Holes
Part No 1154307
Advertisement
