Advertisement
TDX SC with Elevate Only
NOTE: For this procedure, refer to FIGURE 3.
1. Remove the seat cushion.
2. Remove the two socket screws securing the seat pan to the seat frame.
3. Remove the seat pan from the seat frame.
4. Verify seat mounting location (Detail "C") and perform one of the following:
• Seat MUST be Repositioned - Proceed to STEP 5.
• Seat DOES NOT Need Repositioned - Proceed to STEP 10.
5. Remove the eight socket head cap screws, ground washers, and the four strap nuts the
seat frame to the adapter frame.
6. Reposition the seat frame to the adapter frame mounting position according to seat
rail length indicated in Detail "C".
7. Apply Loctite 242 to the eight socket head cap screws.
8. Using the eight socket head cap screws, ground washers, and the four strap nuts,
secure the seat frame to the adapter frame. Torque socket head cap screws to 13 ft-lbs
± 20%.
9. If necessary, re-position front riggings to ensure sufficient clearance for caster wheels.
refer to the seating system owner's manual.
10. Position the seat pan on the seat frame.
11. Secure the seat pan to the seat frame using the two socket screws.
12. Reinstall the seat cushion.
Part No 1154307
13
TDX®SC/Spree Locking Cylinders
Advertisement
