Nortel 6120 Fundamentals page 78

78 WLAN Handset configuration
The WLAN Handset 2211 screen displays the current active channel, the
Caller ID information of the current transmitter, and an indication that the
WLAN Handset 2211 is receiving a broadcast transmission. At the end of a
transmission, the WLAN Handset 2211 enters the waiting state, where it
monitors the channel for up to 10 seconds and displays the Waiting message
on the screen. If no other transmission occurs within 10 seconds, the WLAN
Handset 2211 plays the end call sound and reverts to the idle state.
The user can push the Up and Down buttons to raise or lower the volume of
the PTT transmission. A separate volume is maintained for PTT calls with
the current volume selection retained in memory.
To exit a PTT broadcast, press the Terminate soft key and answer Yes to
the confirmation prompt. PTT audio is immediately stopped and the WLAN
Handset 2211 exits the PTT session. No other WLAN Handset 2211 is
affected. Only the current PTT call is terminated for this WLAN Handset
2211. When another PTT call starts, the WLAN Handset 2211 is again
in the receive state. A still-active session can be rejoined by initiating a
PTT call. See
2211" (page
Disable the PTT feature in the on-hook User Menu to prevent receiving
any further PTT calls.
Interaction with telephone calls
You can answer an incoming telephone call during a PTT call session.
To announce an incoming call, the WLAN Handset 2211 rings with a
low-volume ring and displays the system message. To answer the call,
press Power On/Start Call. The PTT call session is preempted and no PTT
audio is heard. After the telephone call ends, press Power Off/End Call to
go back on-hook, at which time PTT becomes active again. If an already
active PTT call is ongoing, the PTT audio starts playing again.
If the user does not answer the telephone call by pressing Power On/Start
Call, the PTT display appears again after the ring stops.
To start a telephone call during a PTT call session, press the Power
On/Start Call key. This causes the two-way radio to be preempted until
the telephone call is ended.
Copyright © 2007, Nortel Networks
.
Procedure 24 "Initiating a PTT call with the WLAN Handset
76).
Note: PTT dialog is interrupted when you answer an incoming
telephone call. After the telephone call ends, PTT dialog resumes if an
active PTT call is still transmitting. For more information, see
with telephone calls" (page
Nortel Communication Server 1000
WLAN Handsets Fundamentals
NN43001-505 01.04 Standard
Release 5.0 4 September 2007
78).
"Interaction