Assa Abloy Conrbin Russwin IN120 WiFi Installation Instructions Manual page 11

IN120 & IN220 Series
Cylindrical Lock
7 IN220 (PoE) Wiring & Installation (Continued)
PoE Door Harness
C
Order of installation may vary. Refer to appropriate sections for instructions.
Hinge-side harness connectors:
• 4-pin male Molex connector
• 6-pin male Molex connector with ground wire
Lock-side harness connectors:
• Ring terminal
• Male RJ45 connector (crimped after cable is fed through door)
Notes:
• Connectors go on only one way. They cannot be plugged to incorrect position.
• Do not force and do not offset connectors.
• Be sure they are completely seated (flush).
4-pin F
6-pin F
PoE Lock
D
Order of installation may vary.
Refer to appropriate sections for instructions.
1. Prop door open.
2. Using the ring terminal, carefully route the assembly
through the door channel to the lock.
*Do not terminate PoE harness (with RJ45 M) until
cable has been routed through door and inside
mounting plate assembly.
See Section 8, S
Copyright © 2016, 2019, 2021, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
4-pin F 4-pin M
Drain Wire
6-pin F 6-pin M
11 - Installing the Connectors.
tep
RJ45-M
Cable
: Cat5e or higher,
26 AWG stranded,
shielded, 100ohm
11
IN220 PoE Lock
Ferrite
Bead*
PoE Harness
(Cat5e or higher) with
ground wire
Ferrite
Bead