Assa Abloy Conrbin Russwin IN120 WiFi Installation Instructions Manual page 14

8 Lock Installation (Continued)
6 Install Lock Body
a. Feed lock body and wire through 2-1/8" diameter hole from outside of door (Fig. 6a).
Be sure latch engages lock body as shown (Fig. 6b).
b. Connect 4-pin connector from lock body to 4-pin on
cassette (Fig. 6c).
Outside Face of Door
c. Temporarily install top throughbolt to hold chassis in door (Fig. 6c).
Fig. 6a
Important: Door must remain open during installation.
Use door stop.
Inside Face of Door
IN220 (PoE) cable
with ground wire
Fig. 6c
14
Copyright © 2016, 2019, 2021, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
IN120 & IN220 Series
Cylindrical Lock
Fig. 6b
Spring Cassette