Assa Abloy Conrbin Russwin IN120 WiFi Installation Instructions Manual page 22

8 Lock Installation (Continued)
B. IN120 (Wi-Fi)
a. Once controller is securely in place, place (6) "AA" alkaline batteries
in the compartment, being careful to align polarity properly.
b. After batteries are installed, there is a slight delay; LED will
flash and the lock motor will cycle.
14 Inside Cover Installation
a. Assemble cover by hooking top edge on inside mounting plate taking care not to pinch
gasket (top edge goes between plate and gasket).
b. Carefully press bottom of cover toward door without pinching any wires.
c. Secure the cover with a security allen wrench.
*Note location of installed ferrite bead (IN220 PoE) and excess wires (Fig. 14a, d).
Fig. 14a
Fig. 14d
22
IN120 & IN220 Series
Cylindrical Lock
Fig. 13b
Fig. 14b
Security
Fig. 14c
Allen Screw
Copyright © 2016, 2019, 2021, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.