Assa Abloy Conrbin Russwin IN120 WiFi Installation Instructions Manual page 20

8 Lock Installation (Continued)
11 Installation of Connectors (Continued)
Important Note: If you are installing IN220 (PoE)*:
E. Pull 5 1/2 inches of Ethernet cable from hole. Strip cable jacket back
3 1/2 inches.
F. Separate (untwist) and straighten (8) Ethernet wires before carefully
feeding through ferrite bead (Fig. 3D).
G. Crimp RJ45 (male) connector on end of wires.
*For more detail, refer to section (7) 'Installation Wiring',
"A - Frame Harness Installation".
12 Installation of Controller
Important Note: Before you install the IN220 (PoE) controller
Apply dielectric grease to connector* located on back of Controller (FIG. 12b, c).
CAUTION - Do not allow debris to enter connector contacts.
Fig. 12a
RJ45-M
Fig. 12b
20
Copyright © 2016, 2019, 2021, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
IN120 & IN220 Series
Cylindrical Lock
Fig. 11d
Feed wires thru ferrite
bead (PoE only)
Crimp wires to
RJ45-M Connector
(PoE only)
*Be sure to apply grease to connector and
recessed area surrounding connector
Fig. 12c