Assa Abloy Conrbin Russwin IN120 WiFi Installation Instructions Manual page 13

IN120 & IN220 Series
Cylindrical Lock
8 Lock Installation (Continued)
3 Install Door Position Switch (DPS)
a. Insert DPS into the raceway on the latch edge of the door.
b. Push wires through raceway toward lock prep.
c. Push DPS firmly into place by hand.
d. Install magnet into door frame. Push firmly into place by hand.
CAUTION: if DPS is not installed or is installed
improperly, door status monitoring features will
not function.
4 Install Latch Bolt
5 Install Strike Plate
Copyright © 2016, 2019, 2021, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Note: DO NOT TAP SWITCH WITH ANY TOOL.
See instruction A7983.
Install latch bolt with beveled bolt facing the strike
using two #8 x 3/4" combination screws (Fig. 4):
Install strike plate using two #12 x 1" combination
screws (Fig. 5):
Optional Strike Box
13
IN220 (PoE) cable
with ground wire
Fig. 3
Fig. 4
Fig. 5