Assa Abloy Conrbin Russwin IN120 WiFi Installation Instructions Manual page 21

IN120 & IN220 Series
Cylindrical Lock
8 Lock Installation (Continued)
12 Installation of Controller (Continued)
a. Insert bottom tab of controller (ensure a clear path) into slot on mounting plate (Fig. 12d, e).
b. Ensure proper alignment of board-to-board connectors (Fig. 12e) while pivoting controller toward door
until two tabs on top click securely into place on mounting plate (Fig. 12d).
CAUTION: To avoid possible damage to board-to-board connectors, care should be taken when securing
13 Supplying Power to the Controller
Important - before inserting PoE plug into PoE connector, apply dielectric grease to top of plug,
covering the pin area (Fig. 13a).
A. IN220 (PoE)
1. Once controller is securely in place, connect RJ45 male
connector to female RJ45 port on controller board (Fig. 13a).
2. If power is enabled, LED will flash and lock motor will cycle.
Copyright © 2016, 2019, 2021, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
controller to mounting plate. If there is resistance when securing, detach controller to determine
cause before re-attaching controller.
Fig. 12d
Click
into
place
Fig. 13a
21
Fig. 12e