Verifying Operation; Cleaning The Pulse Oximeter - Nonin 8600V Operator's Manual

Verifying Operation

CAUTION! The 8600V must be able to measure the pulse properly to obtain accurate SpO
Verify that nothing is hindering the pulse measurement before relying on the SpO
measurement.
Verify that the sensor is properly positioned. Ensure the system is sensing adequate perfusion by observing that the
indicator is blinking green and correlates to the pulse rate for 10 seconds. If the perfusion light is red, yellow, or
flashing erratically, reposition the sensor or try a different sensor.
CAUTION! The use of Xylazine or Detomidine will reduce perfusion sensed by the pulse oximeter and may
inhibit SpO
For the first 2 minutes of operation, the
during power on. During the first two minutes, the audible alarm may be enabled by pressing the
the audible alarm is not permanently disabled, the
operation and the audible alarm will be enabled.
If the alarm is permanently disabled, the
not have any effect on the audible alarm.

Cleaning the Pulse Oximeter

CAUTION! Do not immerse the 8600V in liquid to clean, and do not use caustic or abrasive cleaning agents.
The 8600V Pulse Oximeter may be cleaned with a mild detergent and a soft cloth or with an isopropyl alcohol wipe.
Allow enough time for the 8600V to dry thoroughly before reusing.
measurement.
2
indicator will flash to indicate the audible alarm is temporarily disabled
indicator will illuminate continuously, and pressing the
indicator will not be illuminated after the first 2 minutes of
8
measurement.
2
2
AUDIO
button. If
AUDIO
button will