Nonin 8600V Operator's Manual page 25

Veterinary pulse oximeter

Table of Contents

Real-Time Data Output

Both the 8600V and 8600MV Pulse Oximeters provide real-time output capability to a custom printer via the 15-pin

Sub-D connector labeled as "RECORDING OUTPUT" on the rear of the 8600V.

The information from the 8600V/8600MV in the real-time mode is sent in an ASCII serial format at 9600 baud with 9

data bits, 1 start bit, and 1 stop bit. The data is output at a rate of once per second.

NOTE:

In real-time mode, the 9th data bit is always set to the mark condition. Therefore the

real-time data may be read as 8 data bits, no parity.

During data output, the

for real-time is in the following format:

where "HH" represents the hour the real-time clock is set to, "MM" represents the minutes, "SS" represents the

seconds, "XXX" represents the SpO

displayed as "---" if there is no data available for the data reading.

NOTE:

Pressing the

print).

indicator displays the status of the data transfer as given in Table VI. The data printed out

HH:MM:SS SPO2=XXX HR=YYY

value, and "YYY" represents the heart rate. The SpO

AUDIO

button during real-time printing will force a line to be printed (touch

and heart rate will be

Table of Contents

8600mv