Communications - Nonin 8600V Operator's Manual

Communications

The 8600V may communicate in two forms: serial and analog communications. It may be connected to three different
devices as given in Table IV. Real-time data may be output to all listed devices from a 8600V or 8600MV, and stored
memory data may be output to all listed devices from a 8600MV.
Analog
Serial
Communication Strip Chart
Link Recorder
- Real-time X
- Memory Output
- Real-time
- Memory Output
Table IV: Communications Links
Pin
Number Signal
1 Ground
2 +5 V
3 Analog/Serial
Control
4 Not Connected
5 Not Connected
6 Alarm
7 Pulse
8 Ground
9 Serial Input
10 Serial Output
11 Not Connected
12 SpO 2
13 Pulse
OR
Rate
14 Not Connected
15 +5 V
Table V: Recording Output Interface Assignments
flashing
indicator
green real-time data
transfer
yellow waiting for data
red real-time error
Table VI: Status Indicator During Data Transfer
8586PI PC
Printer Interface (nVISION software)
X
Assignment
System Ground
External +5 VDC Supply
Set high to send (high speed) serial data
Spare Input Line
Spare Output Line
+5 V Activated with Audible Alarm
+5 V Activated with each Pulse
(corresponds to perfusion indicator)
System Ground
0 ± 5 V levels
0 ± 5 V levels
Not Connected
0 to +1 V levels corresponding to 0 to
100% SpO 2
Plethysmographic pulse waveform OR
0 to +1 V levels corresponding to 0 to
250 pulse per minute
Not Connected
+5 VDC Internal Supply
solid flickering
memory data printing memory
transfer
data in memory
memory error printing error
21
X
data
scrolling