Table of Contents
Advertisement
Option Switches
Option Switch 1
This switch controls the audible alarm OFF capabilities.
down:
Audible Alarm Cannot Be Disabled
Prevents audible alarm from being permanently disabled by the user
up:
Audible Alarm May Be Disabled
Allows the audible alarm to be permanently disabled by the user via the alarm volume dial turned to OFF
Option Switch 2
This switch controls the rate of averaging of the pulse rate and SpO
down:
Fast Response Mode
Pulse rate = 8-beat averaging;
SpO
= 4-beat exponential average
2
up:
Slow Response Mode
Pulse rate = 16-beat averaging;
SpO
= 8-beat exponential average
2
Option Switch 3
Option switch 3 controls the analog output sequence for calibration of strip chart recorders.
NOTE:
This switch has no effect if you are not using the analog communications (strip chart
recorders).
down:
Standard Calibration Sequence
Output analog values step from 0% to 100% to 50%
up:
Alternate Calibration Sequence
Output analog values step from 0% to 100% in increments of 5%, and then to 127% for out-of-range
Option Switch 4
Option switch 4 controls the analog output format to pin 13 of the output connector.
down:
Analog Pulse Waveform:
Output analog (0 - 1 VDC) waveform for the pulse rate
up:
Analog Pulse Rate:
Output analog (0 - 1 VDC) value for pulse rate in the range of 0 to 250 pulses per minute
MEMORY
CLEAR
Button (8600MV Only)
The data within the internal memory is retained until it is cleared or overwritten by new data. To clear the internal
memory the pulse oximeter is first placed in the "memory output mode" After the Memory Output Mode is entered, the
memory is cleared by pressing and holding the
seconds. This will cause the 8600MV to count quickly through all its memory locations, clearing each one.
Pressing the
NOTE:
MEMORY
CLEAR
button located on the rear of the monitor for a minimum of 5
MEMORY
button during normal operation will not clear memory.
CLEAR
17
data.
2
Advertisement
Table of Contents
