Table of Contents
Advertisement
®
™
Anybus
Wireless Bridge II CAN
Reset Using Easy Config
To reset Bridge II CAN to factory default, execute Easy Config Mode 2.
See
Activate an Easy Config Mode in the Built-In Web Interface (page
Reset Using AT Command
To reset Bridge II CAN to factory default, issue the AT command AT&F and then restart the unit.
See
Configuration with AT Commands (page
Page 60 of 72
18).
25).
Reset to Factory Default
SCM-1202-184 2.0
Advertisement
Table of Contents
Need help?
Do you have a question about the Anybus Wireless Bridge II CAN and is the answer not in the manual?