Table of Contents
Advertisement
Traditional 510(k) of Fetal & Maternal Monitor
F15 Series Fetal & Maternal Monitor User Manual
NIBP CUFF TYPE
ERROR
NIBP LEAK
NIBP Signal Weak
NIBP
SIGNAL
INTERFERED
NIBP
EXCEEDS
MEASUREMENT
RANGE
NIBP TIME OUT
SpO
LOW
2
PERFUSION
SpO
SENSOR
2
OFF
SpO
EQUIP
2
MALF
TEMP
UNPLUGGED
TEMP EXCEEDS
MEASUREMENT
RANGE
TEMP Calibration
Failed
Flow abnormal
4.18.3 FTS-3 Technical Alarm Messages
When FTS-3 is connected to F15 series fetal/maternal monitor, the monitor gives
technical alarms for the situations that need the physicians to pay attention to during
wireless monitoring, the alarm messages are listed below.
014_14.1_F15_Series_User_Manual
A different cuff other than the one
supplied by the manufacturer is
used.
The cuff, hose and (or) connector
are (is) damaged.
Cuff is too loose or the patient
pulse is too weak.
Large signal noise or irregular
pulse rate caused by excessive
motions of the patient.
The blood pressure exceeds the
measurement limits.
Measuring time has exceeded
120 seconds.
The signal received by SpO
sensor is too weak, or the
measurement
part
perfusion, and therefore the result
may be inaccurate.
SpO
sensor
is
2
connected.
The
SpO
board
2
communicate with the system
successfully.
TEMP transducer is not well
connected.
The temperature exceeds the
measurement limits.
Calibration
of
the
transducer failed.
Abnormal network traffic has been
detected. The data traffic exceeds
the limit.
Use
the
manufacturer.
Check and replace the leaking part(s).
Contact the manufacturer for service if
required.
Use other methods to measure NIBP.
Keep the arm that is wrapped with the cuff
still.
Check the connection of the cuff and the
patient's condition.
Start measuring again, or use other
measuring methods.
2
Check
the
reposition the SpO
has
low
manufacturer for service if the problem
persists.
not
well
Check the connection of SpO
finger placement.
cannot
Restart the monitor and try again, contact
the manufacturer if the connection still
fails.
Check
transducer.
Check the connection of the TEMP
transducer and the patient's condition.
Restart the monitor and try again. Contact
TEMP
the manufacturer for service if the
problem persists.
Disconnect the network to make the
monitor work properly, and then contact
the
professionals
manufacturer
problem.
- 66 -
cuff
supplied
patient's
condition
sensor. Contact the
2
sensor and
2
the
connection
of
authorized
to
check
the
Alarms
by
the
and
TEMP
by
network
82／202
Advertisement
Table of Contents
