Connecting Power Cable - EDAN F15 Series User Manual

Traditional 510(k) of Fetal & Maternal Monitor
F15 Series Fetal & Maternal Monitor User Manual
NOTE:
1
Be careful when inserting paper. Avoid damaging the thermosensitive print head.
2
Make sure the paper is evenly loaded in the drawer. Otherwise the data will be inaccurate or
paper jam will happen.
3
Only use the paper the manufacturer approved to avoid poor printing quality, deflection,
paper jam or failure to recover traces.
4
Keep the drawer closed unless when loading paper or servicing.
Removing Paper Jam
When the recorder does not function or sound properly, open the drawer to check for a paper jam.
Remove the paper jam in this way:
Cut the recorder paper from the paper drawer edge.
Through the hole on the bottom panel of the paper drawer, push the recorder paper up with one
finger. Remove the paper.
Reload paper and then close the drawer.

2.5 Connecting Power Cable

Make sure the AC power supply of the monitor complies with the following specification: 100V-240V~,
50Hz/60Hz.
Apply the power cable provided with the monitor. Plug one end of the power cable to the power socket
of the monitor. Connect the other end to a three-slot power output special for hospital usage.
If the protective grounding (protective earth) system is doubtful, the power of the monitor must
be supplied by internal power supply only.
NOTE:
1 Make sure the monitor and the power outlet are placed at a place where it is easy to
connect and disconnect the power cord.
2 When the supply mains is interrupted, the device switches to internal power supply
and operates normally if the battery is installed. If the battery is not installed, the
monitor shuts down and resumes the previous settings at the subsequent operation.
3 If the system is powered off and then turned on, the alarm setup will resume to the
setup which is set before the power-off.
014_14.1_F15_Series_User_Manual
WARNING
- 11 -
Installation
27／202