Every Two Weeks - Kodak X-Omat 2000 Operator's Manual

OPERATORS MANUAL

Every Two Weeks

Biweekly Cleaning of the Racks and
Figure 12
Crossover Assemblies
DRYER
ASSEMBLY
CROSSOVER
ASSEMBLIES
DETECTOR
CROSSOVER
ASSEMBLY
16
GUIDE
SHOE
FEED
SHELF
H172_1001CCB
H172_1001CC
Warning
Dangerous Voltage. Disconnect the main power before
doing any of the following cleanup procedures.
[1] Turn off the Main Power Switch.
[2] Disconnect the main power.
[3] Turn off the water supply.
[4] Remove the Top Cover.
Caution
• When removing the Crossover Assemblies, be
careful to maintain squareness, and do not disturb
the Guide Shoes.
• Use a synthetic sponge and warm water. Do not
use any abrasive material on the Racks,
Crossover Assemblies, or Squeegee Rollers.
• Do not rinse the Detector Crossover Assembly or
the Dryer Assembly.
[5] Remove the Evaporation Covers and the
Crossover Assemblies.
(a) Rinse the Evaporation Covers.
(b) Rinse the developer/fixer and fixer/wash
Crossover Assemblies in warm water.
[6] Rotate and clean the Rollers with a soft brush and
warm water.
[7] Dry the Rollers with a damp cloth or synthetic
sponge.
[8] Wipe off all chemical deposits above the solution
level in the processing section.
[9] Remove the Dryer Assembly.
[10] Clean off debris or buildup from the dryer area and
Dryer Assembly with a warm, damp sponge or
cloth.
19JAN99 – 7C8770