Installing And Setting Up Firstgear-User Installation; Figure 3-1. Firstgear Introductory Window - NETGEAR PS104 Installation And Reference Manual

Installation and Reference for the Model PS104/PS105/PS110/PS113 Print Server
To install and set up your network and your print server for the NETGEAR print server, you must
be using a PC with a Windows 95, Windows 98, Windows NT 3.51, or later operating system and
with either the TCP/IP protocol or the NetBEUI protocol enabled.
Note: Before proceeding with these instructions, be sure to assign a name to your
workgroup on your PC. NETGEAR strongly recommends that you exit all Windows
programs before running the Setup program. It is also necessary to install the FirstGear
software on every PC in the network that will use the printers attached to the Model
PS104/PS105/PS110/PS113 print server.
Installing and Setting Up FirstGear—User Installation
To install the NETGEAR print server software for user installation:
Turn on the power to your PC.
1.
Insert the NETGEAR Resource CD-ROM.
2.
The NETGEAR window briefly opens, and the FirstGear introductory window, as illustrated
in Figure 3-1, opens.
If it does not, click on Start > Run and then type in "Install.exe" at the prompt (for example,
"D:Install.exe") to start the installation process.
Figure 3-1. FirstGear Introductory Window
3-2 Microsoft Windows 95 and Windows 98 Printing