Setting Up Spooled Lpr Printing With Windows Nt 3.51; Table 4-1. Fields And Descriptions For Tcp/Ip Configuration - NETGEAR PS104 Installation And Reference Manual

Installation and Reference for the Model PS104/PS105/PS110/PS113 Print Server
Type the subnet mask and gateway address (if DHCP is disabled) or proceed to step 7.
6.
Click on the Save To Device button to download the new print server configuration.
7.
Click on Return to Main Menu to exit the Advanced Configuration window.
8.
Click on Exit on the main menu, and proceed to the next section,
9.
LPR Printing with Windows NT
Table 4-1. Fields and Descriptions for TCP/IP Configuration
Field Description
DHCP This option allows you to enable or disable the print server's ability to get its IP address from
a DHCP (Dynamic Host Configuration Protocol) server. When disabled, you can provide a
fixed IP address in the IP address, Gateway address, and Subnet Mask fields (listed in this
table).
IP Address This IP address is assigned to the print server. If you have a private LAN and do not plan to
connect to the TCP/IP-based Internet, NETGEAR recommends that you use an address
from the IETP-designated private addresses (for example, 192.168.x.x or 10.x.x.x).
Gateway This IP address is what the print server uses for stations with IP addresses not reachable on
Address your local LAN.
Subnet Mask This subnet mask defines the range of addresses that are reachable on your local LAN.
Your print server is now set up to use the TCP/IP protocol for networking. If you enable DHCP,
you must prepare the DHCP server to receive a DHCP query from the print server. Then reset the
print server so it can then obtain an IP address from the DHCP server.
If you run into any difficulty with the static IP Setup, there is the possibility that you inadvertently
disabled the DHCP protocol and/or assigned a wrong subnet IP address. Proceed to
"IP Setup," for more information to help you force a static IP address to the print server.

Setting Up Spooled LPR Printing with Windows NT 3.51

Before starting the PC configuration, you must configure the print server for using TCP/IP as
described in "Configuring the Print Server Using
To prepare for spooled LPR printing:
Click on the Network icon in the Control Panel.
1.
The Network Settings dialog box opens.
4-28
3.51.
TCP/IP" on
Microsoft Windows NT and Windows 2000 Printing
"Setting Up Spooled
page 4-24.
Appendix E,