Tcp/Ip Configuration - NETGEAR PS104 Installation And Reference Manual

Installation and Reference for the Model PS104/PS105/PS110/PS113 Print Server
Table 7-10. NetWare Print Server Mode Fields (continued)
Field
NDS Context
(NDS mode only)
Novell PSERVER (P1)
Novell PSERVER (P2)
TCP/IP Configuration
Table 7-11 lists the fields for TCP/IP configuration, describes their functions, and explains how
to provide information in each field. For additional information about IP addressing, refer to
Appendix B, "Understanding IP
Table 7-11. TCP/IP Configuration Fields
Field Description
DHCP This field allows you to enable or disable the print server from getting its IP address from a
DHCP (Dynamic Host Configuration Protocol) server. When disabled, you can provide a
fixed IP address in the IP Address, Gateway Address, and Subnet Mask fields (listed in this
table).
IP Address This IP address is assigned to the print server. If you have a private LAN and do not plan to
connect to the TCP/IP-based Internet, NETGEAR recommends that you use an address
from the IETP-designated private addresses (for example, 192.168.x.x or 10.x.x.x).
Gateway This IP address is what the print server uses for stations with IP addresses not reachable on
Address your local LAN.
Subnet Mask This subnet mask defines the range of addresses that are reachable on your local LAN.
7-18
Description
Enter the Print Server NDS Context. The entry should contain the path to the
context but not the context itself, and each OU should be separated by a period (for
example, department.company). This entry field is valid only when the print server
is operating in PSERVER mode.
Enter the name of the NetWare print server to service the PRINTER 1 port of the
print server (valid only when operating in RPRINTER mode).
Enter the name of the NetWare print server to service the PRINTER 2 port of the
print server (valid only when operating in RPRINTER mode).
Addresses."
Using Advanced Management Tools