NETGEAR PS104 Installation And Reference Manual page 160

Installation and Reference for the Model PS104/PS105/PS110/PS113 Print Server
Table C-1. Configuration Settings (continued)
Parameter and Command
Subnet Mask
(4002 MASK)
TCP Session Retry Interval
(4010 TCP_INT)
Retry Count
(4011 TCP_CNT)
L1 Logical Printer Mapping
(0100 L1_PROUT)
String Before Job for L1 Logical Printer
(0101 L1_PREST)
String After Job
(0102 L1_POSTR)
Convert LF to CR+LF
(0103 L1_CHGLF)
C-2
Definition
If the Gateway Address is 0.0.0.0, leave the Subnet Mask at
0.0.0.0. If you have a router, enter the Subnet mask for the
segment to which the print server is attached.
Sets how long the print server should wait before retrying a
TCP/IP connection that is lost. Allowable values are from 0 to
255 seconds, with 2 as the default.
Sets how many attempts for reconnection will be made. After
attempting the set number, the TCP/IP session is terminated.
Allowable values are from 0 to 255, with 254 as the default.
The physical port that this L1 logical printer maps to.
The L1 logical printer control string (in hex) to be sent to the
printer before each print job. Note: A printer control string is
limited to 15 characters.
Examples are:
• ASCII = [Esc]&l0O
Hexadecimal = 1B266C304F
• ASCII = [Esc]&l1O
Hexadecimal = 1B266C314F
The L1 logical printer control string (in hex) to be sent to the
printer after each print job. Note: A printer control string is
limited to 15 characters.
Examples are:
• ASCII = [Esc]&l0O
Hexadecimal = 1B266C304F
• ASCII = [Esc]&l1O
Hexadecimal = 1B266C314F
If On, LF (line feed) characters are changed to CR+LF
(carriage return + line feed). If off, no conversion is done.
CONFIG File