Two Ways To Log In To The Wgps606; How To Log In Using The Ip Address Of The Wgps606 - NETGEAR WGPS606 Reference Manual

Reference Manual for the NETGEAR 54 Mbps Wireless USB Print Server with 4-Port Switch

Two Ways to Log In to the WGPS606

The NETGEAR 54 Mbps Wireless USB Print Server with 4-Port Switch WGPS606 can be
configured from Microsoft Internet Explorer browser version 5.0 or above, or Netscape Navigator
Web browser version 4.78 or above. You can log in to the WGPS606 in these two ways:
• Using the Smart Wizard on the WGPS606 CD is the easiest.
• Using the IP address of the WGPS606.
The procedure for using the IP address to log in to the WGPS606 is presented here.

How to Log in Using the IP Address of the WGPS606

The Smart Wizard on the WGPS606 CD guides you through the process of assigning an IP
1.
address based on the addressing scheme used in your network. If you used the Setup Wizard to
perform the initial configuration, you will need to use the IP address assigned at that time.
Otherwise, 192.168.0.102 is the default IP address of your wireless USB print server. So, if the
WGPS606 has not yet been installed, and there is no DHCP server on the network, you can log
in to the WGPS606 using its default IP address.
Note: The computer you are using to connect to the WGPS606 should be configured with a
static IP address that starts with 192.168.0.x and a Subnet Mask of 255.255.255.0.
Open a Web browser such as Internet Explorer or Netscape Navigator.
2.
Connect to the WGPS606 by entering its IP address into your browser.
3.
A login window like the one shown below opens:
4.
Figure 3-3: Login window
Basic Installation and Configuration
202-10083-01
3-7